PROGRAMMER 

PICkit 3, USB, 2 to 6V, Support Programmer to Go up to 512KB

  • PICkit 3 In-Circuit Debugger
  • Part Number: PG164130
  • Microchip’s PICkit 3 In-Circuit Debugger/Programmer uses in-circuit
  • Debugging logic incorporated into each chip with Flash memory to provide a
  • low-cost hardware debugger and programmer. In-circuit debugging offers
  • these benefits:
  •  Low cost
  • Minimum of additional hardware needed for debug
  •  Expensive sockets or adapters are not required
  • The PICkit 3 can now also reprogram any PIC microcontroller
  • with a simple push of a button:
  • Find out more about Programmer-To-Go function
  • Note: The PICkit 3 In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for
  • Development purposes only.
  • The MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most
  • Affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment
  • (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be
  • Connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and
  • MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and
  • In-Circuit Serial Programming™.
  • PICkit 3 Features
  • USB (Full speed 12 Mbits/s interface to host PC)
  •  Real-time execution
  • MPLAB IDE compatible (free copy included)
  • Built-in over-voltage/short circuit monitor
  •  Firmware upgradeable from PC/web download
  • Totally enclosed
  •  Supports low voltage to 2.0 volts (2.0v to 6.0v range)
  •  Diagnostic LEDs (power, busy, error)
  •  Read/write program and data memory of microcontroller
  •  Erase of program memory space with verification
  • Freeze-peripherals at breakpoint
  •  Program up to 512K byte flash with the Programmer-to-Go 

QUICK ENQUIRY
DOWNLOAD CATALOG 

DEVICE LIST