IC PROGRAMMER 

TL866A USB High Performance Programmer

The Outstanding advantages of TL866A programmer
1. Support simultaneously burn with 4 Programmers each computer
2. The Minimum Volume and the lowest Power Consumption and Do not Feel any Heat in Process.
3. All chips do not need external power supply, the low power consumption of its own to ensure that the USB port can provide enough power.
4. Best internal 40 foot over voltage protection, the strongest VCC/VPP 4-level overcurrent protection. The short-circuit do not reset the PC.
5. Wide range of chip 13000+ support, support for serial and parallel series 40/44/48PIN large capacity FLASH
6. Unique serial ICSP interface. supporting the serial download and high-speed parallel high voltage programming. Note: TL866CS does not support ICSP 
7. Test CMOS4000 74/54 series integrated circuit. Can be located in the gate circuit error.
8. Chip auto serial number is the most complete and practical.
9. Original chip encryptionoperation on AVR microcontroller with internal RC Calibration byte. The Decrypt software can not be directly run on another same type of chip.

VIEW DETAILS

TL866CS - Universal Device Programmer for Laptop Bios

High Speed Programming:This programmer has Built-in MCU with high-performance and high-capacity USB interface ,at the communication speed of 12Mbps, being in line with ( For each chip) well-designed programming algorithm and USB high-speed communications. It may be one of the fastest integrated development programmers, the speed has been met the needs of small-quantity efficient production. 
Compared to similar products, some chips' programming speed is several times faster, even more than 10 times. For 4Mbits parallel FLASH ROM, the upgrade programmer (Version 3.01 or above) takes only about 35 seconds to finish programming (the total time of erase, write, verify). It only takes about 32 +79 seconds to read and write a 32MB TE28F320. In most cases, the parallel flash chip can be programmed at the same time it can be verified. The programming will be immediately stopped if there is an error. It only takes about 12 sec (read) +18 sec (write) to read and write an 8 Mbits of serial 25P80. It only takes about 98 sec +160 sec to read and write a chip of 64MB capacity. It supports common 8-PIN and 16-PIN 25 series chip with large capacity.
Note: 16MB or larger capacity flash chip cannot be programmed by general programmers because of programming speed, while the TL866 programmer can widely support 64MB Serial and parallel series of chips to 48PIN. It provides with the remarkable quality that is distinct from other common programmer.

VIEW DETAILS

SP8-A Programmer

USB2.0 communication interfaces (real USB interfaces, not USB to serial ports or simulated USB ports)
Exquisite shells customized with opening moulds, small (size: 103x71x23mm), and convenient to use
and carry
Built-in 32bit high-speed processors, designed specially for serial memories, achieving high-speed and
appropriate programming
Supports nearly all 93/24/25/BR90 memories, and supports more chips through software upgrade
Supports ISP program. On-board patch chips can be directly connected to be programmed
Standard 40Pin ZIF socket, applicable to wide/narrow chips and general adapters
Supports contact detection for pins, thus improving the reliability of programming
Perfect over-current and ESD protection, and protection against accidental damages caused by
misplaced or destroyed chips to programmers and computer USB ports
With mass production program, SP8 automatically detects the position of chips and then starts program
operation
Supports mass asynchronous program by connecting several programmers to one computer. Plug and
write. No synchronous waiting. Top speed and high efficiency
You can choose offline program: built-in 128Mbit data memories achieve different kinds of field
programming without connection to a computer, and LED and buzzer present voice prompt for success
or failure. It operates easy and you can perform mass program
Supports low-voltage (3.3V) and 5V chips
Provides self-detection for devices
Supports WinXP, VISTA, Win7(32bit/64bit

VIEW DETAILS

RT809F Serial ISP USB Universal EPROM FLASH Programmer

1) Read and write 8 pin and 16 pins chips those commonly used on computer motherboard, laptop, LCD, routers and home appliances.
2)Read and write memory SPD DDR1/DDR2/DDR3 Free demolition chip, especially support 34C02 and other special part numbers.
3)Support laptop 8 pin and 14 pin password chip and battery chip (especially 24RF08/6480AR/BR9080/9016 special part numbers
4)Support all series of 24,IIC EEPROM Memory.Besides, it can automatically identify chip model from 24C01 to 24C16,Automatic identify write protection level of the 24 series’ 7th pin.
5) Support all series of 25 and 26 SPI FLASH Memory,support identify the chips part number automaticly,the capacity is up to 256Mbit.
6) Support all series 93 MircroWire Memory, including Japanese special chips.
7) It is the only one programmer which have the function of supporting RTD2120 chip’s double bank read and write online. Including the BANK0 which the firmware in and BANK1 area, which menu in. It can read double BANK in only 6 seconds. Support RTD2122 ‘s three BANK read and write online.
8) Support reading and writing DDC-EDID data of LCD display and LCD TV online. Very easy to solve EDID data problems.
9) Support reading and writing laptop screen  EDID data online, very easy to solve the problem of DELL and SONY laptop’s choose screen. Our store have screen wires sale.

VIEW DETAILS

Newest Stager VS4000 universal programmer Support Bios EEprom FLASH 24 25 93 memory MCU 40pins IC Burner AVR 51 PIC

VSpeed (speed) VS4000 programmer/burn, has the following features:
1- adopt universal 40PIN Socket.
2-enjoy free software upgrades, and can be downloaded for free on our website to update the software. Subsequent will add more support of IC chips, programming is always makes you buy the latest, enjoy the VIP service.
3-USB2.0 on-line operation with a PC, without external power supply, easy to use and carry.
4-Software compatibility Windows2K/XP/Vista / WIN
5-Careful self protection way. Effective assurance does not damage the user IC and programmer/burn itself.

VIEW DETAILS

RT809H Universal Programmer for EMMC CAR DVD SMART TV BIOS

Can automatically detect chip number for all Chips.
Can put ic in any position and make intelligent sense.
Support Read and program Laptop I/O via keyboard line.
Support Read and Program LCD TV VIA VGA and HDMI PORT.
Support ADD new flash by yourself without wait for factory.
Built in Most of repair applications TV,DVD,DVB,and many isp software.
Make selftest for LCD TV itself and diagnostic fault.
Read and programing flash on motherboard without removing out
Support Read and Programming OTP area .
Support UPTO 64GB NAND FLASH

VIEW DETAILS

PICkit 3, USB, 2 to 6V, Support Programmer to Go up to 512KB


The PG164130 is a PICkit 3 in circuit debugger/programmer uses in circuit debugging logic incorporated into each chip with Flash memory to provide a low cost hardware debugger and programmer.The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC flash microcontrollers using the powerful graphical user interface of the MPLAB integrated development environment (IDE).
PICkit 3 allows debugging and programming of PIC and dsPIC Flash MCU's
Expensive sockets or adapters are not required
Minimum of additional hardware needed for debug
Built in over voltage/short circuit monitor
Supports low voltage up to 2volts
MPLAB PICkit 3 contains full speed USB interface to host PC
Compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE
Erase of program memory space with verification
Program up to 512K byte flash with the Programmer to go function
Freeze peripherals at breakpoint1

VIEW DETAILS